Zanussi ZDF2020 User Manual download pdf (Page 11)

Cancelling a delay start:

1. Press and hold the start/cancel button until, the start/

cancel indicator light and delay start indicator light

go off.

2. Press the start/cancel button to start the washing

programme.

End of the washing programme

Switch off the appliance in these conditions:

• The appliance stops automatically.

• The end indicator light comes on.

For better drying results, keep the door ajar for some mi-

nutes before you remove the dishes.

Let the dishes cool down before you remove them from

the appliance. Hot dishes are easily damaged.

Removing the load

• First remove items from the lower basket, then from

the upper basket.

• There can be water on the sides and door of the appli-

ance. Stainless steel becomes cool more quickly than

the dishes.

Care and cleaning

Warning! Switch the appliance off before you clean

the filters.

Cleaning the filters

Important! Do not use the appliance without the filters.

Make sure that the installation of the filters is correct.

Incorrect installation will cause unsatisfactory washing

results and damage to the appliance.

Fully clean the filters A, B

and C below running wa-

ter.

To remove filters B and C,

turn the handle approxi-

mately 1/4 anticlockwise.

Remove the flat filter A

from the bottom of the ap-

pliance.

Put the flat filter A in the

bottom of the appliance.

Install the flat filter cor-

rectly under the two

guides D.

Put the filter system in po-

sition. To lock the filter

system, turn the handle

clockwise until it locks in

position.

Important! Do not remove the spray arms.

If the holes in the spray arms become clogged, remove

remaining parts of soil with a cocktail stick.

External cleaning

Clean the external surfaces of the appliance and control

panel with a damp soft cloth. Only use neutral detergents.

Do not use abrasive products, scouring pads or solvents

(acetone, trichloroethylene etc...).

Frost precautions

Caution! Do not install the appliance where the

temperature is below 0 °C. The manufacturer is not

responsible for damage because of frost.

If not possible, empty the appliance and close the door.

Disconnect the water inlet hose and remove water from

the water inlet hose.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Zanussi ZDF2020 User Manual Page 11

Comments to this Manuals

Related products and manuals for Dishwashers Zanussi ZDF2020