Zanussi ZDT111 User Manual download pdf (Page 27)

Setting and starting a washing programme

Set the washing programme with the door ajar. The

washing programme only starts after you close the

door. Until then it is possible to modify the settings.

Do these steps to set and start a washing programme:

1. Switch on the appliance.

2. Make sure that the appliance is in setting mode.

3. Press the programme selection/cancel button again

and again to set the washing programme. Refer to the

chapter 'Washing programmes'.

– The programme indicator light comes on.

4. Close the door.

– The washing programme starts automatically.

When the washing programme operates, you cannot

change the programme. Cancel the washing pro-

gramme.

Warning! Only interrupt or cancel a washing

programme if necessary.

Caution! Open the door carefully. Hot steam can

come free.

Cancelling a washing programme

1. Press and hold the programme selection/cancel but-

ton for approximately 3 seconds.

– The programme indicator light goes off.

– The end indicator light starts to flash.

2. Release the programme selection/cancel button to

cancel the washing programme.

At this time you can do these steps:

1. Switch off the appliance.

2. Set a new washing programme.

Fill the detergent dispenser with detergent before you set

a new washing programme.

Interrupting a washing programme

Open the door.

• The programme stops.

Close the door.

• The programme continues from the point of interrup-

tion.

End of the washing programme

Switch off the appliance in these conditions:

• The appliance stops automatically.

• The audible signals for the end of the programme op-

erate.

1. Open the door.

– The end indicator light comes on.

– The programme indicator light stays on.

2. Press the on/off button.

3. For better drying results, keep the door ajar for some

minutes before you remove the dishes.

Let the dishes cool down before you remove them from

the appliance. Hot dishes are easily damaged.

Removing the load

• First remove items from the lower basket, then from

the upper basket.

• There can be water on the sides and door of the appli-

ance. Stainless steel becomes cool more quickly than

the dishes.

Care and cleaning

Warning! Switch the appliance off before you clean

the filters.

Cleaning the filters

Important! Do not use the appliance without the filters.

Make sure that the installation of the filters is correct.

Incorrect installation will cause unsatisfactory washing

results and damage to the appliance.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 87 88

Comments to this Manuals

No comments

Zanussi ZDT111 User Manual Page 27

Comments to this Manuals

Related products and manuals for Dishwashers Zanussi ZDT111