Zanussi ZDT311 User Manual download pdf (Page 16)

Warning! To discard the appliance, follow the

procedure:

• Pull the mains plug out of the socket.

• Cut off the mains cable and mains plug and discard

them.

• Discard the door catch. This prevents the children to

close themselves inside the appliance and endanger

their lives.

Installation

Warning! Make sure that mains plug is

disconnected from the mains socket during

installation.

Important! Obey the instructions in the enclosed template

to:

• Build-in the appliance.

• Install the furniture panel.

• Connect to the water supply and drain.

Install the appliance under a counter (kitchen worktop or

sink).

If a repair is necessary, the appliance must be easily ac-

cessible for the engineer.

Put the appliance adjacent to a water tap and a drain.

For the venting of the dishwasher only water fill, water

drain and power supply cable openings are necessary.

The dishwasher has adjustable feet to allow the adjust-

ment of the height.

Make sure that the water inlet hose, the drain hose and

the supply cable are not kinked or squashed, when you

insert the machine.

Attaching the appliance to the adjacent units

Make sure that the counter below which you attach the

appliance is a safe structure (adjacent kitchen units, cab-

inets, wall).

Adjusting the level of the appliance

Make sure that the appliance is level to close and seal the

door correctly. If the level of the appliance is correct, the

door does not catch on the sides of the cabinet. If the door

does not close correctly, loosen or tighten the adjustable

feet until the appliance is level.

Water connection

Water inlet hose

Connected the appliance to a hot (max. 60°) or cold water

supply.

If the hot water comes from alternative sources of energy

that are more environmentally friendly (e.g. solar or pho-

tovoltaic panels and aeolian), use a hot water supply to

decrease energy consumption.

Connect the inlet hose to a water tap with an external

thread of 3/4”.

Caution! Do not use connection hoses from an old

appliance.

The water pressure must be in the limits (refer to the

chapter 'Technical data'). Make sure that the local water

authority gives you the average mains pressure in your

area.

Make sure that there are no kinks in the water inlet hose

and that the water inlet hose is not squashed or entangled.

Turn the inlet hose to the left or the right to suit the in-

stallation. Fit the locknut correctly to prevent water leaks.

Caution! Do not connect the appliance to new pipes

or pipes that are not used for a long time. Let the

water run for some minutes, then connect the inlet hose.

Water inlet hose with safety valve

The water inlet hose is a double-walled and has an inner

mains cable and a safety valve. The water inlet hose is

under pressure only while the water is running. If there is

a leak in the water inlet hose, the safety valve interrupts

the running water.

Warning! Danger-

ous voltage

Be careful when you connect the water inlet hose:

1 2 ... 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Zanussi ZDT311 User Manual Page 16

Comments to this Manuals

Related products and manuals for Dishwashers Zanussi ZDT311