Zanussi ZDT311 User Manual Page 1

GBUser manual 2DishwasherZDT311

12Do these steps to move the upper basket to the upper orlower position:1. Move the front runner stops (A) out.2. Pull the basket out.3. Put the baske

Multitab functionThe multitab function is for combi detergent tablets.These tablets contain agents such as detergent, rinse aidand dishwasher salt. So

2. Release function buttons B and C to cancel the wash-ing programme.At this time you can do these steps:1. Switch off the appliance.2. Set a new wash

3To remove filters B and C,turn the handle approxi-mately 1/4 anticlockwise.4Remove the flat filter Afrom the bottom of the ap-pliance.5Put the flat f

Fault code and malfunction Possible cause and solution• continuous flash of the light of the run-ning programme• intermittent audible signal• 1 flash

The cleaning results are not satisfactoryThe dishes are not clean • The selected washing programme is not applicable for the type of load andsoil.• Th

Warning! To discard the appliance, follow theprocedure:• Pull the mains plug out of the socket.• Cut off the mains cable and mains plug and discardth

• Do not put the water inlet hose or the safety valve inwater.• If the water inlet hose or the safety valve is damaged,immediately disconnect the main

18

19

ContentsSafety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 3Washing programmes _ _ _ _ _ _ _ _

www.zanussi.com156950310-00-022009

• Do not change the specifications or modify this prod-uct. Risk of injury and damage to the appliance.• Do not use the appliance:– if the mains cable

Indicator lightsThe indicator light comes on when the washing pro-gramme is completed. Auxiliary functions:• Level of the water softener.• Activation/

Washing programmesWashing programmesProgramme Degree of soil Type of load Programme descriptionHeavy soil Crockery, cutlery, potsand pansPrewashMain w

Use of the applianceRefer to the following instructions for each step of pro-cedure:1. Make a check if the water softener level is correct forthe wate

12Set switch to position 1 or2.Electronic adjustmentThe water softener is set at the factory at level 5.1. Switch on the appliance.2. Make sure that t

Use of rinse aidCaution! Only use branded rinse aid fordishwashers.Do these steps to fill the rinse aid dispenser:1 2345Fill when the rinse aid in-di

1Arrange service dishesand large lids around theedge of the lower basket.23The rows of prongs in thelower basket can be flat toload pots, pans and bow