Zanussi ZDT311 User Manual Page 13

  • Download
  • Add to my manuals
  • Print
  • Page
    / 20
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 12
3
To remove filters B and C,
turn the handle approxi-
mately 1/4 anticlockwise.
4
Remove the flat filter A
from the bottom of the ap-
pliance.
5
Put the flat filter A in the
bottom of the appliance.
Install the flat filter cor-
rectly under the two
guides D.
6
Put the filter system in po-
sition. To lock the filter
system, turn the handle
clockwise until it locks in
position.
Important! Do not remove the spray arms.
If the holes in the spray arms become clogged, remove
remaining parts of soil with a cocktail stick.
External cleaning
Clean the external surfaces of the appliance and control
panel with a damp soft cloth. Only use neutral detergents.
Do not use abrasive products, scouring pads or solvents
(acetone, trichloroethylene etc...).
Frost precautions
Caution! Do not install the appliance where the
temperature is below 0 °C. The manufacturer is not
responsible for damage because of frost.
If not possible, empty the appliance and close the door.
Disconnect the water inlet hose and remove water from
the water inlet hose.
What to do if…
The appliance does not start or stops during operation.
If there is a fault, first try to find a solution to the problem
yourself. If you cannot find a solution to the problem
yourself, contact the Service Force Centre.
Caution! Switch off the appliance before you do the
below suggested corrective actions.
Fault code and malfunction Possible cause and solution
continuous flash of the light of the run-
ning programme
intermittent audible signal
1 flash of the end indicator light
The dishwasher does not fill with water
The water tap is blocked or furred with limescale.
Clean the water tap.
The water tap is closed.
Open the water tap.
The filter in the water inlet hose is blocked.
Clean the filter.
The connection of the water inlet hose is not correct. The hose can
be kinked or squashed.
Make sure that the connection is correct.
13
Page view 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments