Zanussi ZRG616CW User Manual Page 36

  • Download
  • Add to my manuals
  • Print
  • Page
    / 40
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 35
Installing the appliance
Transportation, unpacking
It is recommended to deliver the appliance in original
packaging, in vertical position considering the protective
warning on packaging.
After each transportation the appliance must not be
switched on for approx. 4 hours.
Unpack the appliance and check if there are damages on
it. Report possible damages immediately to the place you
bought it. In that case retain packaging.
Cleaning
Remove every adhesive tape, which ensure the parts not
to move in the appliance.
Wash the inside of the appliance using lukewarm water
and mild detergent. Use soft cloth.
After cleaning wipe out the inside of the appliance.
Placement
The ambient temperature has an effect on the energy con-
sumption and proper operation of the appliance. When
placing, take into consideration that it is practical to oper-
ate the appliance between ambient temperature limits
according to the climate class that is given in the chart
below and can be found in the data label.
Class of climate Ambient temperature
SN +10 ... +32 °C
N +16 ... +32 °C
ST +16 ... + 38 °C
T +16 ... + 43 °C
If the ambient temperature goes below the lower data the
temperature of the cooling compartment can go beyond
the prescribed temperature.
If the ambient temperature goes beyond the upper data
this means longer operating time of the compressor,
breakdown in the automatic defrosting increasing temper-
ature in the cooling compartment or increasing energy
consumption.
When placing the appliance ensure that it stands level.
This can be achieved by two adjustable feet (1) at the bot-
tom in front. 1-1 piece of distance washer (2) are acces-
sories of the adjustable feet. If levelling the appliance
requires, these washers can be removed.
36
Do not stand the appliance on a sunny place or close to a
radiator or cooker.
If it is unavoidable because of furnishing and the appli-
ance has to be stood near a cooker take these minimum
distances into consideration:
In case of gas or electric cooker 3 cm must be left,
when it is less put a 0,5-1 cm non-flam insulation
between the two appliances.
In case of oil or coal-fired stove the distance must be
30 cms since they give off more heat.
The refrigerator is designed to operate when it is totally
pushed to the wall.
When placing the refrigerator keep minimal dis-
tances recommended in figure.
A : placing it under a wall-cupboard
B : placing it freely
Change of door opening direction
Should the setting-up place or handling demand it, door-
opening direction can be refitted from right-handed to left-
handed.
Following operations are to be done on the basis of fig-
ures and explanations:
Pull out the plug from the mains socket.
Tilt back the appliance carefully being careful so that
the compressor can not touch the floor. It is recom-
mended to ask another person for help, who can
keep the appliance at this position safely.
GB
Page view 35
1 2 ... 31 32 33 34 35 36 37 38 39 40

Comments to this Manuals

No comments