Zanussi ZCG551GNC User Manual download pdf (Page 8)

Hob - Daily use

Warning! Refer to the Safety chapters.

Lighting the burners

Warning! Be very careful when you use

open fire in a kitchen environment. The

manufacturer declines all responsibility in case

of misuse of the flame.

Always light the burner before you put

cookware on it.

1.

Turn the knob to the maximum position

and push it down. When you push the

knob, the spark generator activates auto-

matically.

2. Keep the control knob pushed for approxi-

mately 5 seconds. This lets the thermocou-

ple warm up. If not, the gas supply is inter-

rupted.

3. Adjust the flame after it is regular.

If after some tries the burner does not

light, check if the crown and its cap are in

the correct positions.

8

7

6

9

3

4

5

2

1

1

Burner cap

2

Burner crown

3

Ignition candle

4

Thermocouple

5

Hob

6

Slots

7

Burner body

8

Location peg

9

Hole

Replacing burner parts

1. Carefully put the burner crown on the

burner body. Do not use force.

a) Make sure that the hole in the crown is

above the ignition candle.

b) Make sure that the location pegs are in

the slots in the burner body.

c) Let the crown fall freely onto the body.

d) Make sure that you can move the

crown a small distance from side to

side.

2. Put the burner cap centrally on top of the

crown (enamel side up). Move the cap from

side to side and front to back to make sure

that it is correctly installed.

3. Try to light the burner. If the burner does

not ignite, adjust the crown and cap again.

Warning! Do not keep the control knob

pushed for more than 15 seconds.

If the burner does not light after 15 seconds,

release the control knob, turn it into off position

and try to light the burner again after minimum

1 minute.

If the burner accidentally goes out, turn the

control knob to the off position and try to

light the burner again after minimum 1 minute.

The spark generator can start automatical-

ly when you switch on the mains, after in-

stallation or a power cut. It is normal.

8

www.zanussi.com

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Comments to this Manuals

No comments