Zanussi ZWD1261 User Manual Page 24

  • Download
  • Add to my manuals
  • Print
  • Page
    / 56
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 23
Installation
Unpacking
All transit bolts and packing must be removed before us-
ing the appliance.
You are advised to keep all transit devices so that they can
be refitted if the machine ever has to be transported again.
After removing all the
packaging, carefully lay
machine on it's back to re-
move the polystyrene base
from the bottom.
Remove the power supply
cable and the drain hose
from the hose holders on
the rear of the appliance.
Unscrew the three bolts. Slide out the relevant plas-
tic spacers.
Open the porthole and re-
move the polystyrene
block fitted on the door
seal and all objects inside
the drum.
Fill the smaller upper hole
and the two large ones
with the corresponding
plastic plug caps supplied
in the bag containing the
instruction booklet.
Positioning
Install the machine on a flat hard floor. Make sure that air
circulation around the machine is not impeded by carpets,
rugs etc. Check that the machine does not touch the wall
or other kitchen units. Level the washing machine by rais-
ing or lowering the feet. The feet may be tight to adjust as
they incorporate a self locking nut, but the machine MUST
be level and stable.
Any necessary adjustment can be made with a spanner.
Accurate levelling prevents vibration, noise and displace-
ment of the machine during operation. Never place card-
board, wood or similar materials under the machine to
compensate for any unevenness in the floor.
If necessary, check the
setting with a spirit level.
Water inlet
Caution!
This appliance must be connected to a cold water
supply
Before connecting up the appliance to new pipe-
work or to pipework that has not been used for
some time, run off a reasonable amount of water
to flush out any debris that may have collected
Do not use the hose from your previous appli-
ance to connect to water supply.
The inlet hose is supplied and can been found inside the
machine drum.
24
www.zanussi.com
Page view 23
1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 55 56

Comments to this Manuals

No comments