Zanussi ZWF1423 User Manual

ENUser manualWashing MachineZWF 1223ZWF 1423

ProgrammeMaximum and Minimum TemperatureCycle DescriptionMaximum Spin SpeedMaximum Fabrics LoadType of LaundryOptionsDetergentCompartmentSOAK 30°Prewa

ProgrammeMaximum and Minimum TemperatureCycle DescriptionMaximum Spin SpeedMaximum Fabrics LoadType of LaundryOptionsDetergentCompartment = OFFFor can

Off Mode (W) Left On Mode (W)0.10 0.98The information given in the charts above are in compliance with the EU Commission regulation 2015/2010implement

The detergent and any additives must beplaced in the appropriate compartments of thedispenser drawer before starting the wash pro-gramme.If using liqu

Daily useLoad the laundryOpen the door bycarefully pulling thedoor handle out-wards. Place thelaundry in the drum,one item at a time,shaking them out

Start the programme by pressing button 7To start the selected programme, press thisbutton; the corresponding green pilot lightstops blinking.The pilot

(Pay attention to the water level and tem-perature!).After closing the door, it is necessary to selectthe programme and options again and to pressbutt

Cleaning the drawer recessHaving removed thedrawer, use a smallbrush to clean the re-cess, ensuring that allwashing powder resi-due is removed fromthe

Make sure that the impeller of the pump canturn. If this does not occur, contact the serv-ice centre.21Clean the filter under the water tap and put it

1. disconnect the mains plug from the mainssocket.2. close the water tap3. unscrew the water inlet hose from the tap;4. put the two ends of the inlet

Contents_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2Safety instructions _ _ _ _ _ _ _ _ _ _ _ _ _ _ 3Product description _ _ _ _ _ _ _ _ _ _

Problem Possible cause/SolutionThe machine does not start:The door has not been closed. • Close the door firmly.The plug is not properly inserted in t

Problem Possible cause/SolutionUnsatisfactory washing re-sults:Too little detergent or unsuitable detergent has been used.• Increase the detergent qua

If you are unable to identify or solve the prob-lem, contact our service centre. Before tele-phoning, make a note of the model, serial num-ber and pur

Unscrew the threebolts.Slide out the relevantplastic spacers.Open the portholeand remove the poly-styrene block fittedon the door seal andall objects

Connect the hose toa tap with a 3/4”thread.• After positioning the inlet hose, be sure totighten the ring nuts again to prevent leaks.• The inlet hose

Environment concernsThe symbol on the product or on itspackaging indicates that this product may notbe treated as household waste. Instead itshould

26 www.zanussi.com

27www.zanussi.com

www.zanussi.com/shop 132933801-A-322012

• Obey the maximum load volume of 7 kg (refer to the “Programmechart” chapter).• If the supply cord is damaged, it must be replaced by the manu-factur

• The appliance is to be connected to the wa-ter mains using the new supplied hose-sets.Old hose sets must not be reused.• Before you connect the appl

Detergent dispenser drawer Compartment for detergent used for pre-wash and soak phase or for stain remover usedduring the stain action phase (if avail

1 2 3 4 5 6 7 81091Programme selector dial2SPIN reduction button3OPTIONS button4PREWASH button5EASY IRON button6EXTRA RINSE button7START/PAUSE button8

quantity of water (extra rinse), select this option.Some additional rinses will be performed. Thisoption is recommended for people who are al-lergic t

Programme chartProgrammeMaximum and Minimum TemperatureCycle DescriptionMaximum Spin SpeedMaximum Fabrics LoadType of LaundryOptionsDetergentCompartme

ProgrammeMaximum and Minimum TemperatureCycle DescriptionMaximum Spin SpeedMaximum Fabrics LoadType of LaundryOptionsDetergentCompartmentWOOL 40°Main