Zanussi ZWG5140P User Manual download pdf (Page 9)

Water inlet

Connect the hose to

a tap with a 3/4”

thread.

35°

45°

Loosen the ring nut to angle the hose to the

left or right depending on the position of your

water tap. Do not place the inlet hose

downwards. After positioning the inlet hose,

be sure to tighten the ring nut again to pre-

vent leaks.

Water drainage

Firstly form a hook in the end of the drain

hose using the plastic hose guide supplied

with the appliance .

The end of the drain hose can be positioned

in four ways:

• Hooked over the edge of a sink using

the plastic hose guide.

Tie the plastic hose guide to the tap with a

string to prevent that the drain hose unhooks

when the appliance is emptying.

• Onto a sink outlet spigot.

Push the drain hose onto the spigot and se-

cure with a clip, ensure a loop is formed in

the drain hose to prevent waste from the sink

entering the appliance.

If the outlet spigot has not been used before,

remove any blanking plug that may be in

place.

• Directly into a drain pipe at a height of

not less than 60 cm and not more than

100 cm.

MAX 100cm

The end of the drain

hose must always be

ventilated, i.e. the

inside diameter of the

drain pipe must be

larger than the out-

side diameter of the

drain hose. The drain

hose must not be

kinked.

• Directly to a built-in drain pipe in the

room wall.

9

www.zanussi.com

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 55 56

Comments to this Manuals

No comments