Zanussi ZFX31401WA User Manual download pdf (Page 21)

www.zanussi.com

Problem Possible cause Solution

The water drainage plug is not

correctly positioned.

Position the water drainage plug

in the correct way.

Food products are not wrapped

properly.

Wrap the food products better.

Temperature is set incorrectly. Refer to “Operation” chapter.

The temperature in the appliance

is too low/too high

The temperature regulator is not

set correctly.

Set a higher/lower temperature.

The food products’ temperature

is too high.

Let the food products tempera-

ture decrease to room tempera-

ture before storage.

The thickness of the frost is

greater than 4-5 mm.

Defrost the appliance.

The door has been opened often. Open the door only if necessary.

There is no cold air circulation in

the appliance.

Make sure that there is cold air

circulation in the appliance.

If the advice does not lead to the desired

result, call the nearest brand-mark ser-

vice.

Closing the door

1. Clean the door gaskets.

2. If necessary, adjust the door. Refer to

“Installation”.

3. If necessary, replace the defectivedoor

gaskets. Contact the ServiceCenter.

Installation

WARNING! Refer to Safety chapters.

Positioning

This appliance should be installed in a dry,

well ventilated indoor climate where the ambi-

ent temperature corresponds to the climate

class indicated on the rating plate of the

appliance:

Climate class Ambient temperature

SN +10ºC to +32ºC

N +16ºC to +32ºC

ST +16ºC to +38ºC

T +16ºC to +43ºC

Some functional problems might occur

for some types of models when operating

outside of that range. The correct opera-

tion can only be guaranteed within the

speciﬁed temperaturerange. If you have

any doubts regarding where to install the

appliance, please turn to the vendor, to

our customer service or to the nearest

Service Centre

Location

WARNING! It must be possible to

disconnect the appliance from the mains

power supply; the plug must therefore be

easily accessible after installation.

The appliance should be installed well away

from sources of heat such as radiators, boil-

ers, direct sunlight etc. Ensure that air can cir-

culate freely around the back of the cabinet.

To ensure best performance, if the appliance

is positioned below an overhanging wall unit,

the minimum distance between the top of

the cabinet and the wall unit must be at least

100mm.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 58 59

Comments to this Manuals

No comments

Zanussi ZFX31401WA User Manual Page 21

Comments to this Manuals

Related products and manuals for Freezers Zanussi ZFX31401WA