Zanussi ZRG16605WA User Manual download pdf (Page 21)

CAUTION! To carry out the following

operations, we suggest that this be

made with another person that will

keep a firm hold on the doors of the

appliance during the operations.

1. Unscrew both screws on the rear side.

2. Push back the top and lift it.

3. Unscrew the left foot.

4. Unscrew the screws of the door bottom hinge.

Remove the hinge. Put over the pin in the

direction of the arrow.

5. Unscrew and install the screw on the opposite

side.

6. Install the hinge on the opposite side.

7. Screw the right foot.

8. Unscrew the screws of the door top hinge.

9. Remove the hinge. Put over the pin in the

direction of the arrow. Install the hinge on the

opposite side.

1

2

3

10. Tighten the hinge.

11. Put the top in position.

12. Push front the top.

13. Screw both screws on the rear side.

14. Remove and install the handle on the opposite

side.

1

2

3

Do a final check to make sure that:

• All screws are tightened.

• The magnetic seal adheres to the

cabinet.

• The door opens and closes

correctly.

If the ambient temperature is cold (i.e.

in Winter), the gasket may not fit

perfectly to the cabinet. In that case,

wait for the natural fitting of the gasket.

In case you do not want to carry out

the above mentioned operations,

contact the nearest Authorised

Service Centre. The Authorised

Service specialist will carry out the

reversibility of the doors at your cost.

ELECTRICAL CONNECTION

• Before plugging in, ensure that the voltage and

frequency shown on the rating plate correspond

to your domestic power supply.

21

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 47 48

Comments to this Manuals

No comments