Zanussi ZDT 6255 Instruction Manual download pdf (Page 15)

What to do, when...

Certain problems are due to the lack of simple maintenance or oversights, which can be solved with the help of the instructions

given here, without calling out an engineer.

...a flashing fault code appears

The dishwasher will not start or stops during operation.

Open the dishwasher door.

The intervention of an alarm is indicated by:

- continuous flashing of the indicator light of the washing programme in progress,

- a combination of flashing and pauses of the END OF CYCLE indicator light and of intermittent audible signals (as described in the

chart).

Carry out the following suggested corrective actions.

Important: If you call out an engineer to a fault listed below or to repair a fault caused by incorrect use or installation a charge will

be made, even if the appliance is in guarantee.

Once the checks have been carried out, to continue the programme press the button of the programme that was running before the

intervention of the alarm and close the door. The programme will continue from the point at which it was interrupted. If the fault code

reappears contact your local Service Force Centre.

For other combinations of fault codes not described in the above chart will appear, please contact your local Service Force Centre.

- indicator light of the washing

programme in progress is flashing

- 1 intermittent audible signal

- 1 flash of the "END OF CYCLE"

indicator light

The machine does not fill with water.

- indicator light of the washing

programme in progress is flashing

- 2 intermittent audible signals

- 2 flashes of the "END OF CYCLE"

indicator light

The dishwasher will not drain.

- indicator light of the washing

programme in progress is flashing

- 3 intermittent audible signals

- 3 flashes of the "END OF CYCLE"

indicator light

Fault code / malfunction Possible cause Solutions

The water tap is blocked or furred with

limescale.

The water tap is turned off.

The filter (where present) in the threaded

hose fitting at the water inlet valve is blocked.

The water inlet hose has not been correctly

laid or it is bent or squashed.

Clean the water tap.

Turn the water tap on.

Clean the filter in the threaded

hose fitting.

Check the water inlet hose

connection.

The sink spigot is blocked. Clean out the sink spigot.

The water drain hose has not been correctly

laid or it is bent or squashed.

Check the water drain hose

connection.

Anti-flood device has activated.

Close the water tap and contact

your local Service Force Centre.

...there are problems when operating the dishwasher

The programme does not start

There is a whistling noise during

washing

Malfunction Possible cause Solutions

The dishwasher door has not been properly

closed.

The main plug is not plugged in.

The fuse has blown in the household fuse box.

Close the door.

Insert the mains plug.

Replace the fuse.

For dishwasher models with delay start

option:

Delay start has been selected.

If dishes are to be washed immediately,

cancel the delay start.

Use a different brand of detergent.

The whistling is not a cause for concern.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Comments to this Manuals

No comments

Zanussi ZDT 6255 Instruction Manual Page 15

Comments to this Manuals

Related products and manuals for Dishwashers Zanussi ZDT 6255