Zanussi ZDE47100W User Manual Page 9

  • Download
  • Add to my manuals
  • Print
  • Page
    / 16
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 8
Cleaning fluff filter
The filter collect all the fluff which accumulates during
drying. To ensure that the dryer works perfectly, the fluff
filter must be cleaned after every drying cycle.
The warning light FILTER , is on to remind you this op-
eration.
Caution! Never operate the dryer without fluff filter
or with damaged or blocked fluff filter.
1. Open loading door
and remove laun-
dry.
2. Remove the filter
which is built into
the lower part of the
loading aperture.
3. Open the filter
pressing the but-
ton, among two
slots on fingers.
Clean the filter us-
ing dump hand or
cloth. After a period
of time, a patina
due to detergent
residue on laundry forms on the filters. When this
occurs, clean the filter with warm water using a brush.
Close the filter and do not forget to put it back.
Warning! Before You place the filter, please check
it there is nothing inside the filter seat.
4. The filter can be positioned only to one side. If po-
sition is wrong, the filter overhangs.
If the filter will not snap into place, the loading door
cannot be closed.
Cleaning the door
Clean periodically the interior part of the door to remove
any fluff. Accurate cleaning ensures correct drying.
Cleaning the drum
Caution! Do not use abrasives or steel wool to clean
the drum.
Lime in the water or cleaning agents may form a
barely visible lining on the inside of the drum. The
degree to which the laundry has been dried is then no
longer detected reliably. The laundry is damper than ex-
pected when removed from the dryer.
Use a standard domestic cleaner (e.g. vinegar-based
cleaner) to wipe down the inside of the drum and drum
ribs.
Clean operating screen and housing
Caution! Do not use furniture cleaners or
aggressive cleaning agents to clean the machine.
Use a damp cloth to wipe down the operating screen and
housing.
What to do if ...
Problem Possible cause Remedy
Dryer does not work.
Mains plug is not plugged in or fuse
is not working correctly.
Plug in at mains socket. Check fuse
in fuse box (domestic installation).
Loading door is open. Close loading door.
Have you pressed the START PAUSE
button?
Press the START PAUSE button
again.
Drying results unsatisfactory.
Wrong programme selected.
Select a different programme the next
time you dry (see “Programme chart”
chapter).
Fluff filter clogged. Clean fluff filter.
Overloading of laundry.
Observe recommended loading vol-
umes.
Ventilation slots covered up. Uncover ventilation slots.
9
Page view 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments