Zanussi ZWG1120M User Manual download pdf (Page 16)

Malfunction

Possible Cause / Solution

The machine stops when the proce-

dure has not been finished

Power failure or water cut.

The water inside the inner barrel has been drained

but there is still a small amount of water in the

drainage pump and pipe. The drainage pump

continuously work and takes in the air, then there

wil be noise which is normal situation.

The machine stops for some time

during the wash procedure.

The washing machine adds water automatically.

There is too much foam in the tube, the foam is

being drained.

Foam spills from the detergent

drawer

Check if the amount of detergent is excessive,

if it is the specialized detergent for the drum

washing machine.

Reduce the amount of detergent used next time.

Dip one scoop of the softener mixed with 1/2 liter

of water to the detergent box II.

If the washing machine cannot work normally, a alarm code will appear on the display. Please carry

out the following checks.

Display

Reason

Solutions

Open the water tap, to check if the inlet hose is squashed

or kinked, check if the filter in the inlet valve is blocked or

not; check if the water pressure is too low.

Check if the drain pump is blocked (see page 11).

Check if the voltage is too high if it is this case, a constant

voltage device is needed.

Inlet water

overtime

Overtime of

the drainage

The door has

not been closed

Voltage is

too high

Check if the door of the washing machine is closed check

if the clothes are trapped by the door seal.

Try to use again or contact your local service center if the

problem persists.

Others

Alarm codes

The drainage pump is noisy during

operation after the water has been

drained.

1 2 ... 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Zanussi ZWG1120M User Manual Page 16

Comments to this Manuals

Related products and manuals for Washing machines Zanussi ZWG1120M