Zanussi ZWI71000WA User Manual download pdf (Page 15)

45°

20°

• Screw the hose back

to the machine and

make sure the

connection is tight.

• Turn on the water tap.

FROST PRECAUTIONS

If the appliance is installed in an area where the

temperature can be less than 0° C, remove the

remaining water from the inlet hose and the drain

pump.

1. Disconnect the mains plug from the mains

socket.

2. Close the water tap.

3. Place the end of the emergency emptying hose

and that of the inlet hose in a bowl placed on

the floor and let water flow out of the hoses.

4. Set the Drain programme and let it operate until

the end of the cycle.

5. Turn the programme knob to to disconnect

the appliance from the power supply.

6. Screw the water inlet hose back on and re-fit

the emergency emptying hose after having put

the cap on again.

WARNING! Make sure that the

temperature is more than 0 °C before

you use the appliance again.

The manufacturer is not responsible

for damages caused by low

temperatures.

FROST PRECAUTIONS

If the appliance does not drain the water, proceed

as follows:

1. Disconnect the mains plug from the mains

socket.

2. Close the water tap.

3. if necessary, wait until the water has cooled

down.

4. Place a bowl on the floor and put the end of

the emergency emptying hose into the bowl.

Remove its cap.

The water should drain by gravity into the bowl.

5. When the bowl is full, put the cap back on the

emergency hose.

6. Empty the bowl. Repeat the procedure until

water stops flowing out.

7. Clean the pump if necessary as previously

described.

8. Replace the emergency emptying hose in its

seat after having plugged it.

9. Screw the water inlet hose back on.

TROUBLESHOOTING

WARNING! Refer to Safety chapters.

INTRODUCTION

The start of the appliance does not occur or it

stops during operation.

First try to find a solution to the problem (refer to

the table). If not, contact the Authorised Service

Centre.

With some problems, the acoustic signals operate.

The red indicator of the button Inicio/Pausa flashes

and one of the phase indicators comes on, to show

an alarm code:

• Prelava./Lava. - The appliance does not fill with

water properly.

• Aclarados/Enxag. Centrifugar - The appliance

does not drain the water.

• Fin/Fim - The appliance door is open or not

closed correctly. Please check the door!

• The indicator of button Inicio/Pausa flashes in

red 11 times and 1 (or 2 or 3) time(s) in green:

the mains supply is unstable. Wait until the

mains supply is stable and the appliance

automatically starts operating.

WARNING! Deactivate the appliance

before you do the checks.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 43 44

Comments to this Manuals

No comments

Zanussi ZWI71000WA User Manual Page 15

Comments to this Manuals

Related products and manuals for Washing machines Zanussi ZWI71000WA