Zanussi ZWO1101 User Manual Page 13

  • Download
  • Add to my manuals
  • Print
  • Page
    / 20
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 12
Clean the filter in the valve with a stiff brush or a
towel.
Install again the inlet hose. Make sure that the cou-
plings are tight to prevent leakages.
Open the water tap.
Emergency drain
Because of a malfunction, the appliance cannot drain the
water.
If this occurs, do steps (1) through (5) of 'To clean the
drain pump'.
If necessary, clean the pump.
When you drain the water with the emergency drain proce-
dure, you must activate again the drain system:
1. Put 2 litres of water in the main wash compartment
of the detergent dispenser.
2. Start the programme to drain the water.
Frost precautions
If the appliance is installed in an area where the tempera-
ture can be less than 0 °C, remove the remaining water
from the inlet hose and the drain pump.
1. Disconnect the mains plug from the mains socket.
2. Close the water tap.
3. Remove the water inlet hose
4. Put the two ends of the inlet hose in a container and
let the water flow out of the hose.
5. Empty the drain pump. Refer to the emergency drain
procedure
6. When the drain pump is empty, install the inlet hose
again.
Warning! Make sure that the temperature is more
than 0 °C before you use the appliance again.
The manufacturer is not responsible for damages caused
by low temperatures.
Troubleshooting
The start of the appliance does not occur or it stops dur-
ing operation.
First try to find a solution to the problem (refer to the ta-
ble). If not, contact the service centre.
Warning! Deactivate the appliance before you do the
checks.
Problem Possible cause Possible solution
The appliance does not
start.
The mains plug is not connected in
the mains socket.
Put in the mains plug.
The fuse in the box fuse is damage. Replace the fuse.
The appliance door is open. Close the door firmly.
You do not press the start button Press the start button.
The programme knob is not in the
correct position.
Turn the programme knob in the correct posi-
tion.
The delay start is set.
It is available only for models with
the Delay start.
To start immediately the programme, cancel the
delay start.
The appliance does not fill
with water.
The water tap is closed. Open the water tap.
13
Page view 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments