Zanussi ZWY180 Basic Guide download pdf (Page 7)

Problems Causes

The washing machine

doesn’t start or doesn’t fill:

• the appliance isn’t plugged in correctly, the electrical installation isn’t working,

• the lid of your appliance and the drum shutters aren’t closed firmly,

• the programme start command hasn’t been properly selected,

• there is a power failure,

• the water supply has been cut off,

• the water inlet tap is closed,

• the water inlet filters are dirty,

• a red tab appears on the water inlet hose.

The appliance fills but emp-

ties straight away:

• the drainage U-piece is fixed too low (see installation section).

The washing machine

doesn’t rinse or doesn’t emp-

ty:

• the drain hose is blocked or bent,

• the object trap is obstructed,

• the out of balance detector has been activated : washing is unevenly distributed

in the drum,

• the “Drain” programme or “Night Silence Plus” or “Rinse hold” option have

been selected,

• the height of the drainage U-piece is unsuitable.

You have found water

around the washing ma-

chine:

• too much detergent has caused foam to overflow,

• the detergent is unsuitable for machine washing,

• the drainage U-piece isn’t attached correctly,

• the water inlet hose is leaking.

Wash is unsatisfactory: • the detergent is unsuitable for machine washing,

• there is too much washing in the drum,

• the wash cycle is unsuitable,

• there isn’t enough detergent.

The appliance vibrates, is

noisy:

• all packaging have not been removed from the appliance (see installation section),

• the appliance isn’t level and is unbalanced,

• the appliance is too close to the wall or furniture,

• washing is unevenly distributed in the drum,

• the load is too small.

The wash cycle is much too

long:

• the water inlet filters are dirty,

• the power or water supply has been cut off,

• the motor overheating detector has been activated,

• the water inlet temperature is lower than usual,

• the foam detection security system has been activated (too much detergent) and

the washing machine has begun draining the foam,

• the out of balance detector has been activated: an extra phase has been added

to distribute washing more evenly in the drum.

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Comments to this Manuals

No comments

Zanussi ZWY180 Basic Guide Page 7

Comments to this Manuals

Related products and manuals for Washing machines Zanussi ZWY180