Zanussi ZDT 6244 Instruction Booklet download pdf (Page 8)

Rinse aid

Rinse aid is automatically added during the last rinse, ensuring

thorough rinsing, and spot and streak free drying.

The dispenser, which is positioned inside the door, holds about

110 ml of rinse aid, which is sufficient for 16 - 40 dishwashing

programmes, depending upon the dosage setting.

Filling with rinse aid

1. Open the container by pressing the release button (A).

2. Add the rinse aid until the container is completely full. The

maximum level for filling is indicated by "max".

Ensure that the lid is closed after every refill.

Clean up any rinse aid spilt during filling with an

absorbent cloth to avoid excess foaming during the next

wash.

Only use branded rinse aid for dishwashers. Never fill the

rinse aid dispenser with any other substances (e.g.

dishwasher cleaning agent, liquid detergent). This would

damage the appliance.

Adjusting the dose

According to the finish and drying results obtained, adjust the

dose of rinse aid by means of the 6 position selector (position

1 minimum dosage, position

6 maximum dosage).

The dose is factory set in

position 4.

Increase the dose if there are

drops of water or lime spots

on the dishes after washing.

Reduce it if there are sticky

whitish streaks on the dishes

or a bluish film on glassware

or knife blades.

Top up the rinse aid when the

indicator (B) becomes clear.

● If you are using dishwasher detergent that already contains

rinse aid, the detergent including the rinse aid must be

placed in the detergent compartment.

In this case the rinse aid dosage must be deactivated in

orderto avoid a double dosage.

Deactivation/activation of the dosage of

rinse aid

(The dishwasher must be switched off)

Factory setting: dosage of rinse aid activated

1. Press the On/Off push button. All programme selection push

buttons indicator lights will illuminate (setting mode).

If only one programme selection push button indicator light

is illuminated, this means that a washing programme has

been selected.

The programme must be cancelled: press simultaneously

the function push buttons 2 and 3 for about 2 seconds, the

indicator light of the set programme push button starts

flashing for about 2 seconds.

After about 2 seconds the indicator lights of all the

programme selection push buttons will illuminate indicating

that the setted programme has been cancelled and that

the machine is now in setting mode.

2. Press simultaneously function push buttons 2 and 3, the

indicator lights of the function push buttons 1, 2 and 3 start

flashing.

3. Press the function push button 2, the indicator lights of

function push buttons 1 and 3 turn off while the indicator

light of the push button 2 goes on flashing, at the same time

the END OF CYCLE indicator light illuminates, indicating

that the dosage of rinse aid is active.

4. To deactivate the dosage of rinse aid, press again the

function push button 2, the END OF CYCLE indicator light

turns off, indicating that the dosage of rinse aid has been

deactivated.

5. To memorise the operation, switch off the dishwasher by

pressing the On/Off push button or wait about 60 seconds

after which the dishwasher will automatically return to

setting mode.

To activate again the dosage of rinse aid simply follow the

above operations until the END OF CYCLE indicator light

illuminates.

BR10

BR16

BR12

BR11

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 24 25

Comments to this Manuals

No comments

Zanussi ZDT 6244 Instruction Booklet Page 8

Comments to this Manuals

Related products and manuals for Dishwashers Zanussi ZDT 6244