Zanussi ZDT311 User Manual download pdf (Page 29)

Fully clean the filters A, B

and C below running wa-

ter.

To remove filters B and C,

turn the handle approxi-

mately 1/4 anticlockwise.

Remove the flat filter A

from the bottom of the ap-

pliance.

Put the flat filter A in the

bottom of the appliance.

Install the flat filter cor-

rectly under the two

guides D.

Put the filter system in po-

sition. To lock the filter

system, turn the handle

clockwise until it locks in

position.

Important! Do not remove the spray arms.

If the holes in the spray arms become clogged, remove

remaining parts of soil with a cocktail stick.

External cleaning

Clean the external surfaces of the appliance and control

panel with a damp soft cloth. Only use neutral detergents.

Do not use abrasive products, scouring pads or solvents

(acetone, trichloroethylene etc...).

Frost precautions

Caution! Do not install the appliance where the

temperature is below 0 °C. The manufacturer is not

responsible for damage because of frost.

If not possible, empty the appliance and close the door.

Disconnect the water inlet hose and remove water from

the water inlet hose.

What to do if…

The appliance does not start or stops during operation. If there is a fault, first try to find a solution to the problem

yourself. If you cannot find a solution to the problem

yourself, contact the Service Force Centre.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 87 88

No comments

Zanussi ZDT311 User Manual Page 29