Zanussi ZFX31401WA User Manual download pdf (Page 22)

22

www.zanussi.com

Ideally, however, the appliance should not

be positioned below overhanging wall units.

Accurate levelling is ensured by one or more

adjustable feet at the base of the cabinet.

It is advisable for there to be 75mm separat-

ing the back of the fridge to the wall, at least

100mm of space at its two sides, height of

over 100mm from its top and a clear space

upfront to allow the doors to open 160°

Door reversibility

WARNING! Before carrying out any

operations, remove the plug from the

power socket.

CAUTION! To carry out the following

operations, we suggest that this be made

with another person that will keep a ﬁrm

hold on the doors of the appliance during

the operations.

1. Remove the top hinge cover.

2. Unscrew the 2 retaining screws, and

remove the hinge from the appliance.

1

1

2

3

4

3. Take the door off.

4. Unscrew the two screws ﬁxing the lower

door hinge (there is a foot ﬁxing on the

hinge, do not remove it from the hinge).

Take the door off.

1

2

5. Then remove the left foot as shown in the

ﬁgure.

6. Fix the door hinge (with the original foot

on it) on the opposite side and then the

loosened foot at the former place as

shown in the ﬁgure.

Make sure to place the screws in the right

holes as shown in the ﬁgure.The edge of

the hinge is parallel with the side of the

cabinet.

Please make sure to place the lower foot be-

low the door hinge. The lower foot is recog-

nizable by its 4ribs on the outer surface.

7. Fix the door onto the lower hinge pin.

8. To ﬁt top door hinge, remove the plastic

screw hole cover carefully, and reﬁt them

in the holes left by the hinge retaining

screws.

9. Reﬁt the top hinge using the 2 retaining

screws, making sure that the edge of the

door is parallel with the side of the cabinet.

10. Replace the hinge cover.

11. Relocate the handle and the plastic plugs

to the opposite side.

1

2

3

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 58 59

Comments to this Manuals

No comments