Zanussi FCS825C User Manual download pdf (Page 18)

Hooked over the edge of a sink using

the plastic hose guide supplied with the

machine.

In this case, make sure the end cannot come

unhooked when the machine is emptying. This

could be done by tying it to the tap with a piece

of string or attaching it to the wall.

In a sink drain pipe with a trap.

650-800 mm

The drain hose can be connected directly into

the pipe (e.g. beneath a washtub or sink), above

the water trap. The drain hose must be arranged

so that some part of it’s length is routed up to a

level corresponding to the top edge of the tub

and fixed in place there.

Directly into a drain pipe at a height of not

less than 65 cm and not more than 80 cm.

Their must be an air gap around and below the

end of drain hose. This means that the internal

diameter of the standpipe must be larger than

the outer diameter of the hose.

650-800 mm

40 mm

The hose must not be sticked into the standpipe

more than 50 mm and it has to be fixed in this

position. The drain hose must not be kinked.

The drain hose can be extended up to total 3,5

m. For the extension piece use a hose with an

internal diameter at least as large as that of the

machine's own hose. Use a suitable hose con-

nector.

Information on the electrical connection is given

on the rating plate on the inner edge of the ap-

pliance door.

Check that your domestic electrical installation

can take the maximum load required, also taking

into account any other appliances in use.

Caution! Connect the machine to an

earthed socket.

Caution! The manufacturer does not

accept any responsibility for damage

or injury through failure to comply with

the above safety precaution.

Caution! The power supply cable must

be easily accessible after installing

the machine.

www.zanussi.com

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 43 44

Comments to this Manuals

No comments

Zanussi FCS825C User Manual Page 18

Comments to this Manuals

Related products and manuals for Washing machines Zanussi FCS825C