Zanussi FL12INPUT User Manual download pdf (Page 25)

Water inlet

Before connecting the hose be sure to fit the mesh filter

«A» supplied as per diagram.

Installation should comply with local water authority

and building regulations’ requirements.

Set the hose correctly by loosening the ring nut. After

positioning the inlet hose, be sure to tighten the ring nut

again to prevent leaks.

Water drainage

This appliance is designed to be permanently plumbed

into your home's water supply and drainage system.

The appliance drain hose should hook into a standpipe,

the hook in the drain hose is formed using the plastic

“U-Piece” supplied.

The standpipe should have an internal diameter of

approximately 38mm (see diagram) thus ensuring there

is an air break between the drain hose and standpipe.

When discharging into a standpipe ensure that the top of

the curve in the hose end is no more than 90cm (35.4'')

and no less than 60cm (23.6'') above floor level. The

upright standpipe should have a minimum length of

30cm (12'') from the bottom of the elbow to the top of

the pipe (see diagram).

Make sure that it is designed in such a way, that the end

of the drain hose cannot be covered with water.

The drain hose may be extended to a maximum of 4

metres. An additional drain hose and joining piece

is available from your local Service Force Centre.

The joining piece must have an internal diameter of

18mm.

If you intend the drain hose to empty into a sink, make

sure that the sink is empty and the plug hole is not

blocked. Use the plastic “U-Piece” supplied.

P0003

P0021

P1039

3 pin

Max. 90 cm.(35.4")

Min.60 cm.

(23.6")

P1040

Min. 30 cm.(12")

38 mm.(1/ ") diameter

standpipe

P0022

1 2 ... 20 21 22 23 24 25 26 27 28

Comments to this Manuals

No comments

Zanussi FL12INPUT User Manual Page 25

Comments to this Manuals

Related products and manuals for Washing machines Zanussi FL12INPUT