Zanussi ZFU19400WA User Manual download pdf (Page 17)

Installation

Important! For electrical connection carefully

follow the instructions given in specific

paragraphs.

• Unpack the appliance and check if there are

damages on it. Do not connect the appli-

ance if it is damaged. Report possible dam-

ages immediately to the place you bought it.

In that case retain packing.

• It is advisable to wait at least four hours be-

fore connecting the appliance to allow the

oil to flow back in the compressor.

• Adequate air circulation should be around

the appliance, lacking this leads to over-

heating. To achieve sufficient ventilation fol-

low the instructions relevant to installation.

• Wherever possible the back of the product

should be against a wall to avoid touching

or catching warm parts (compressor, con-

denser) to prevent possible burn.

• The appliance must not be located close to

radiators or cookers.

• Make sure that the mains plug is accessible

after the installation of the appliance.

• Connect to potable water supply only (If a

water connection is foreseen).

Service

• Any electrical work required to do the serv-

icing of the appliance should be carried out

by a qualified electrician or competent per-

son.

• This product must be serviced by an author-

ized Service Centre, and only genuine spare

parts must be used.

Environment Protection

This appliance does not contain gasses

which could damage the ozone layer, in

either its refrigerant circuit or insulation materi-

als. The appliance shall not be discarded to-

gether with the urban refuse and rubbish. The

insulation foam contains flammable gases: the

appliance shall be disposed according to the

applicable regulations to obtain from your local

authorities. Avoid damaging the cooling unit,

especially at the rear near the heat exchanger.

The materials used on this appliance marked

by the symbol

are recyclable.

Control panel

1 2 3 4 5

1

Green On/Off Indicator Light

2

Temperature Regulator and On/Off

Switch

3

Yellow Fast Freeze Indicator Light

4

Acoustic Signal Stop and Fast Freeze

Switch

5

Red Alarm Indicator Light

Switching on

1. Allow the appliance to stand for 4 hrs af-

ter installation.

2. Insert the plug into the wall socket.

3. Turn the Temperature Regulator clockwise

to a temperature lower than << - 16 °C

>> position.

4. The Green On/Off Indicator Light will light

up and Red Alarm Indicator Light will

blink.

5. The lighting up of the Green On/Off Indi-

cator Light means that the appliance is

switched on.

17

www.zanussi.com

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 55 56

Comments to this Manuals

No comments