Zanussi ZWD14791W User Manual Page 28

  • Download
  • Add to my manuals
  • Print
  • Page
    / 36
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 27
3. Set the hose correctly by loosening the ring nut. Af-
ter positioning the inlet hose, be sure to tighten the
ring nut again to prevent leaks.
The inlet hose must not be lengthened. If it is too short
and you do not wish to move the tap, you will have to pur-
chase a new, longer hose specially designed for this type
of use.
Important! Before connecting up the machine to new
pipework or to pipework that has not been used for some
time, run off a reasonable amount of water to flush out any
debris that may have collected in the pipes.
Warning! Installation should comply with local
water authority and building regulations’
requirements.
The appliance must be connected to a cold water supply.
A minimum water pressure of 0.05 MPa (0.5 bar) is
required for safe operation of the appliance.
If you cannot make the cold water connection direct from
the rising mains, you may be able to operate the appliance
from your cold water storage system.
There should be a minimum vertical distance of 5.02 m
(16.5 ft) between the appliance’s inlet and the bottom of
the water storage tank.
Water drainage
This appliance is designed to be permanently plumbed in-
to your home's drainage system using one of the follow-
ing methods.
1. Into a drainage standpipe
Firstly form a hook in the end of the drain hose using the
“U” piece” supplied.
“U” piece
supplied
Place the drain hose into your standpipe, which should
have an internal diameter of approximately 38 mm thus
ensuring there is an air break between the drain hose and
standpipe.
38 mm (½”)
standpipe
diameter
30 cm (12”)
When discharging into a standpipe ensure that the top of
the standpipe is no more than 90 cm (35.4'') and no less
than 60 cm (23.6'') above floor level.
28
www.zanussi.com
Page view 27
1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34 35 36

Comments to this Manuals

No comments