Zanussi ZWI71000WA User Manual Page 19

  • Download
  • Add to my manuals
  • Print
  • Page
    / 28
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 18
Problem Possible cause/Solution
Spinning starts late or the
machine does not spin:
The electronic unbalance detection device has cut in because the laundry
is not evenly distributed in the drum. The laundry is redistributed by re-
verse rotation of the drum. This may happen several times before the un-
balance disappears and normal spinning can resume. If, after 10 minutes,
the laundry is still not evenly distributed in the drum, the machine will not
spin. In this case, redistribute the load manually and select the spin pro-
gramme.
Redistribute the laundry.
The load is too small.
Add more items, redistribute the load manually and then select the
spinning programme.
The machine makes an un-
usual noise:
The machine is fitted with a type of motor which makes an unusual noise
compared with other traditional motors. This new motor ensures a softer
start and more even distribution of the laundry in the drum when spinning,
as well as increased stability of the machine.
No water is visible in the
drum:
Machines based on modern technology operate very economically using
very little water without affecting performance.
If you are unable to identify or solve the prob-
lem, contact our service centre. Before tele-
phoning, make a note of the model, serial num-
ber and purchase date of your machine: the
Service Centre will require this information.
Mod. ... ... ...
Prod. No. ... ... ...
Ser. No. ... ... ...
Mod
.
.
.
.
...
.
.
.
Prod. N
o.
...
... ..
S
e
r. No
.
... ... ...
Technical data
Dimensions Width / Height / Depth 596 / 820 / 544 mm
Electrical connection Voltage
Overall power
Fuse
Frequency
220-230 V
2000 W
10 A
50 Hz
Water supply pressure Minimum
Maximum
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
Level of protection against ingress of solid particles and moisture IPX4
Water supply
1)
Cold water
Maximum Load Cotton 7 kg
Spin Speed Maximum 1000 rpm
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
19
www.zanussi.com
Page view 18
1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

Comments to this Manuals

No comments