Zanussi ZDK320X User Manual download pdf (Page 24)

290

510



Building In

These hobs can be inserted in a built-in kitchen unit

whose depth is between 550 and 600 mm. The hobs

dimensions are shown in Fig. 2.

Installation and assembly

These hobs can be installed in a kitchen unit with an

opening for insertion whose dimensions are shown in Fig.

The edge of the cut out must have a minimum distance

from the rear wall of 55 mm.

If there are side walls, or sides of the furniture unit near

the hob, the cut out edges must have a minimum

distance of 100 mm.

Hanging forniture units or hoods must be placed at 650

mm minimum from the hob.

Carry out the building in of the hob as follows:

1. Place the sealing gasket (Fig.4 - “A”) all around the

edge of the cut out.

2. Fit the hob in the cut out and push it down until it

comes in contact with the kitchen top surface. Then

remove the excess sealing.

3. To remove the hob from the cut-out, lift the edge of the

hob by means of the edge of a screw-driver.

If several 30cm hob are to be installed side by side

into the same cut out, an assembly kit including

a support side bracket and supplementary

sealings is available at our After Sales Centres.

The relevant installation instructions are supplied

within the kit package.

Dimensions are given in millimetres

Fig. 2

REMOVE

FO 0548

Fig. 4

Fig. 3

550 MIN

591

140

240

490

270

40÷50

650 MIN.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 71 72

Comments to this Manuals

No comments

Zanussi ZDK320X User Manual Page 24

Comments to this Manuals

Related products and manuals for Hobs Zanussi ZDK320X